Lift Arm Catch Adjustment
(Figure 5.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
1
2
3
Figure 5
NOTE: The linkage arm assembly includes a linkage
arm, two ball joints, and two nuts. To allow adjustment,
one of the linkage arm ends has left-hand threads, so
one ball joint and nut also have left-hand threads.
Before attempting to loosen a nut for linkage
adjustment, inspect the visible threads on the linkage
arm to determine thread direction.
2. Loosen jam nuts (1) on linkage arm (2) and turn
linkage arm to achieve a distance of 7.09 in. (180 mm)
between centers of ball joints (3).
3. Make sure that lift arm catch properly engages
lifting arm. It may be necessary to adjust linkage arm
(2) length for proper operation.
4. After completing adjustments, tighten jam nuts (1).
GreensPro 1200
Page 5 - 7
Chassis