Adjustments; Lifting Bar Adjustment - Toro GreensPro 1200 Service Manual

Adjustments

Lifting Bar Adjustment

(Figures 3 and 4.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
2. Raise machine (transport wheels down and locked).
1
3
4 5 6 7 8
3. Support rear of machine to relieve load on tow bar
lever (2).
4. Remove cap screw (4), washer (5), bushing (6),
washer (7), and lock nut (8), and disconnect lifting bar
(3) from tow bar lever (2). Repeat procedure for other
side of machine.
Figure 4
NOTE: One end of the lifting bar has left-hand threads.
Before attempting to loosen the ball joint jam nuts,
inspect the visible ball joint threads to determine which
end of the lifting bar has left-hand threads.
5. Loosen jam nuts (1) on lifting bar (3) and turn lifting
bar to achieve a distance of 26.77 in. (680 mm)
between centers of ball joints (9). Tighten jam nuts (1).
Repeat procedure for other side of machine.
Chassis
Figure 3
9
6. Connect lifting bar (3) to tow bar lever (2) using cap
screw (4), washer (5), bushing (6), washer (7), and lock
nut (8). Repeat for other side of machine.
7. Remove support from rear of machine.
2
Page 5 - 6 GreensPro 1200