Steering Tower - Toro GreensPro 1200 Service Manual

Steering Tower

Removal
(Figures 17 through 25.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
2. Remove steering wheel (see Steering Wheel in this
section).
1 2
Figure 17
3. Remove six cap screws (1) and lock washers (2),
and remove column cover (3).
4
12
Figure 18
4. Remove two cap screws (6), four flat washers (7),
and two lock nuts (8) securing upper bearing assembly
(5) to steering column box (4).
5. Remove four cap screws (9), eight flat washers (10),
and four lock nuts (11). Remove steering column box
(4) from steering column (12).
GreensPro 1200
1 2
NOTE: For assembly purposes, mark the location of
3
the upper bearing assembly (5) on the upper steering
shaft (13).
1 2
6. Loosen two socket head set screws (14), and
remove upper bearing assembly (5) from upper
steering shaft (13).
5
6 7 8
9 10 11
7. Remove four cap screws (15), eight flat washers
(16), and four lock nuts (17).
8. Remove two cap screws (18), four flat washers
(19), and two lock nuts (20), and remove steering
column (12) from chassis (21).
Page 5 - 13
13
5
14
Figure 19
12
21
18 19 20
Figure 20
15 16 17
Chassis