Toro GreensPro 1200 Service Manual page 80

4. Remove lock nut (17), two flat washers (21), nut
(20), and cap screw (24), and disconnect gas spring
(19) from lifting axle (26).
5. Remove lock nut (23), flat washer (20), cap screw
(30), flat washer (29), and bushing (28), and disconnect
lifting bar (27) from lifting axle (26).
6. Remove lock nut (6), flat washer (7), cap screw (14),
flat washer (15), and bushing (12), and disconnect
lifting bar (13) from lifting axle (26).
7. Remove six axle clamp bolts (1), lock washers (2)
and flat washers (3), and remove three axle clamp
plates (4) and axle clamps (5).
8. Remove lifting axle (26).
Installation
(Refer to Figure 74.)
1. Place bottom halves of axle clamps (5) on vehicle
frame, positioning them above the mounting holes.
2. Place lifting axle (26) on axle clamps (5), positioning
welded flanges between outer axle clamps.
3. Install upper halves of axle clamps (5) and axle
clamp plates (4), and secure, using six flat washers (3),
lock washers (2), and axle clamp bolts (1). Tighten axle
clamp bolts (1) to 35 ft-lb (47.5 N·m).
4. Before securing lifting bars to lifting axle, check that
the length of the lifting bars is 26.77 in. (680 mm)
between centers of ball joints. Adjust lifting bar if
necessary (see Lifting Bar Adjustment in the
Adjustments section of this chapter).
5. Connect lifting bar (13) to lifting axle (26) using
bushing (12), cap screw (14), flat washer (15), flat
washer (7), and lock nut (6).
6. Connect lifting bar (27) to lifting axle (26) using
bushing (28), cap screw (30), flat washer (29), flat
washer (22), and lock nut (23).
7. Connect gas spring (19) to lifting axle (26) using cap
screw (24), nut (20), two flat washers (21), and lock nut
(17).
8. Release latch, and raise transport axle.
9. Install transport wheel hubs. (See Transport Wheel
Hub in this section.)
10.Install transport wheels. (See Transport Wheel in
this section.) Make sure that wheel lug nuts are
properly tightened to 80 lb-ft (108 N·m).
Chassis Page 5 - 36 GreensPro 1200