Toro GreensPro 1200 Service Manual page 65

Installation
(Figures 42 through 44.)
1. If steering linkage assemblies were disassembled,
refer to Figure 37 for correct linkage length. Leave hex
nuts on linkage loose until final steering adjustments
have been completed.
1
12
11
Figure 42
2. Install linkage arm (6) to front steering head
assembly (11), and secure with cap screw (7), lifting
handle bushing (8), flat washer (9), and lock nut (10).
3. Install other end of linkage arm (6) to steering disc
assembly (1), and secure with cap screw (2), lifting
handle bushing (3), flat washer (4), and lock nut (5).
4. Repeat steps 1 and 2 to connect rear steering
linkage arm to rear steering head assembly (12).
13
17
1
Figure 43
5. Install steering pivot rod (15) to steering disc
assembly (1), and secure with cap screw (16), two
plated washers (17), flat washer (14), and lock nut (13).
GreensPro 1200
2 3 4 5
6
7
8 9
10
15
14
16
Page 5 - 21
18
Figure 44
6. Install other end of steering pivot rod (15) to steering
pivot assembly (18), and secure with cap screw (19),
plated washer (20), flat washer (21), and lock nut (22).
7. Adjust linkage as necessary (see Steering Linkage
Adjustments in the Adjustments section of this
chapter).
8. Lower machine to the ground.
15
19 20 21 22
Chassis