Transport Wheel Hub - Toro GreensPro 1200 Service Manual

Transport Wheel Hub

Removal
(Figure 73.)
1. Bearing (2 used)
2. Spacer
3. Transport wheel hub
4. Cap screw
5. Lock washer
6. Spacer
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from spark plug.
2. Remove transport wheels. (See Transport Wheel in
this section.)
3. Remove cap screw (4), lock washer (5), and spacer
(6).
4. Remove transport wheel hub (3).
5. Inspect bearings (1) and replace as necessary.
Chassis
1
2
3
6
5
Figure 73
Installation
(Refer to Figure 73.)
1. Install transport wheel hub (3), and align spacer (2)
as necessary.
2. Install spacer (6), lock washer (5), and cap screw
(4).
1
3. Install transport wheels. (See Transport Wheel in
this section.) Make sure that wheel lug nuts are
properly tightened to 80 lb-ft (108 N·m).
4
Page 5 - 34 GreensPro 1200