Toro GreensPro 1200 Service Manual page 82

Be careful when removing or installing spring.
The spring is under heavy load and may cause
personal injury.
4. Disconnect spring (13) from wheel lock (15).
5. Remove two nuts (11), flat washers (10), and cap
screws (14), and remove linkage arm assembly (12).
6. Remove two lock nuts (6), and remove wheel lock
plate (5), wheel lock assembly (15), and two nuts (2).
NOTE: The linkage arm assembly includes a linkage
arm, two ball joints, and two nuts. To allow adjustment,
one of the linkage arm ends has left-hand threads so
one ball joint and nut also have left-hand threads.
Before attempting to loosen a nut for linkage
disassembly, inspect the visible threads on the linkage
arm to determine thread direction.
Installation
(Refer to Figure 75.)
1. Install wheel lock plate (5) and wheel lock assembly
(15) using two nuts (2) and lock nuts (6). Tighten lock
nuts (6) so wheel lock plate and wheel lock assembly
do not move; then loosen lock nuts to allow wheel lock
plate and wheel lock assembly to move freely.
2. If linkage arm assembly (12) was disassembled,
adjust linkage arm length so distance between centers
of ball joints is 7.09 in. (180 mm).
3. Install linkage arm assembly (12) using two cap
screws (14), flat washers (10), and nuts (11).
Be careful when removing or installing spring.
The spring is under heavy load and may cause
personal injury.
4. Connect spring (13) to wheel lock assembly (15).
5. Make sure that wheel lock is engaged and remove
blocks from under transport wheels.
6. Check operation of lift arm catch and adjust linkage
arm assembly if required (see Lift Arm Catch
Adjustment in the Adjustments section of this chapter).
Chassis
CAUTION
CAUTION
Page 5 - 38 GreensPro 1200