Maintenance And Service - Toro GreensPro 1200 Service Manual

Maintenance and Service

1. The Operator's Manual and engine Owner's Manual
provide information regarding the operation, general
maintenance, and maintenance intervals for your
GreensPro machine. Refer to these publications for
additional information when servicing the machine.
2. Before servicing or making adjustments to the
machine, stop the engine and wait for all machine
motion to stop. Remove the spark plug wire from the
spark plug to prevent accidental starting of the engine.
If Greenspro is attached to tow vehicle, apply tow
vehicle parking brake, stop engine, and remove key
from ignition switch.
3. To make sure entire machine is in good condition,
keep all nuts, bolts, screws, and belts properly
tightened.
4. To reduce potential fire hazard, keep the engine
area free of excessive grease, grass, leaves, and
accumulation of dirt.
5. If the engine must be running to perform
maintenance or make an adjustment, keep hands, feet,
clothing, and all parts of the body away from all moving
parts. Keep bystanders away.
6. Do not overspeed the engine by changing governor
settings. Recommended engine high idle speed is
3200 rpm. To ensure safety and accuracy, check
engine speed with a tachometer.
7. Engine must be shut off and cooled down before
checking oil or adding oil to the engine crankcase.
8. When performing general maintenance and service
on the machine, it is recommended that the machine
be parked on a clean, level surface with the transport
wheels in the raised and locked position. The machine
will be more stable when positioned on the rollers.
9. If service of underdeck items (e.g., steering or
transmission linkage) is necessary, raise machine with
hoist or other lifting device. Support raised machine
with appropriate jackstands on all corners of the
machine to prevent it from shifting or falling. Excessive
tilting of the machine should be avoided.
10.When lowering machine from transport position,
make sure that the ground is clean and level. This will
prevent unexpected movement of the machine and
potential roller damage.
11.If major repairs are necessary or assistance is
required, contact your Authorized TORO Distributor.
GreensPro 1200
12.At the time of manufacture, the machine conformed
to all applicable safety standards. To ensure optimum
performance and continued safety certification of the
machine, use genuine TORO replacement parts and
accessories. Replacement parts and accessories
made by other manufacturers may result in non-
conformance with the safety standards and the
warranty may be voided.
13.When disposing of hazardous waste products, take
them to an authorized disposal site. Waste products
must not be allowed to contaminate surface water,
drains, or sewer systems.
Page 1 - 3 Safety