Toro GreensPro 1200 Service Manual page 76

6. Apply a thin film of oil to outside diameter of hub
(15) before installation.
7. Install key (16) and hub (15), aligning the three
holes in the hub and sprocket.
8. Install and tighten two set screws (13).
19
18
25
20
24
23
22 21
Figure 71
9. Install drive chain tension assembly (23) using cap
screw (24), spacer (20), flat washer (25), two flat
washers (18), and lock nut (19).
10. Install flat washer (22) and nut (21).
NOTE: If additional chain tension adjustment is
needed, both nuts on tension rod can be installed on
outside of frame bracket.
11. Adjust drive chain tension and lubricate chain.
®
(Refer to Operator's Manual.) Dri-Slide Multi-Purpose
Lubricant (or equivalent) is recommended for
lubrication.
After drive chain adjustment, the drive chain should
have 0.200 in. to 0.300 in. (5 to 8 mm) deflection at
mid-span between the sprockets.
12. Install and secure transmission cover (see
Transmission Cover in this section).
13. Lower machine to the ground.
Chassis Page 5 - 32 GreensPro 1200