Oil Tank - Toro GreensPro 1200 Service Manual

Oil Tank

Removal
(Figures 18 through 20.)
1. Park machine on a clean, level surface with the
transport wheels in the raised and locked position.
Make sure engine is OFF. Remove spark plug wire
from the spark plug.
2. Move motion pedals to relieve system pressure.
3. Remove transmission cover from machine (see
Transmission Cover in the Service and Repairs section
of Chapter 5 - Chassis).
4. Drain hydraulic oil from oil tank into a suitable
container.
2
Figure 18
5. Thoroughly clean hose end and fittings on the oil
tank to prevent oil system contamination.
6. Label all hoses and fittings for assembly purposes.
Remove hoses (1 and 2) from fittings on oil tank. Drain
hoses into a suitable container.
7. Put clean plugs in disconnected hoses and fittings
to prevent system contamination.
Hydraulic System
1
Page 4 - 16
3
4 5 6
Figure 19
8. Remove two lock nuts (4), two cap screws (5), and
four flat washers (6).
9. Remove oil tank assembly (3). If oil tank is being
replaced, proceed to next step.
4 5 6
GreensPro 1200