Toshiba strata CT Installation & Maintenance Manual page 121

PACU Programming
H
C
Strata CT I&M Manual October 2000
Program 03: Specify code 14 for slots that support PACUs and make sure the BRCS is
enabled for DTMF operation.
Program 04: Specifies [PDNs]. These are also the numbers that must be received by
incoming Tie Lines to route calls to the proper telephones.
Program *09: Assigns Tie Line Ringing to ACD Groups.
Program 10-1: Enables/disables two-line conference.
Program 10-4: Assigns Toll Restriction (maximum number of Tie line calls dialling
simultaneously)
Program 10-5: Assigns privacy on the tie line transferred calls.
Program 12: Assigns various timing operations to the PACU.
Program 15: Assigns tandem connection, exchange line signalling and recall.
Program16: Assigns the tie lines to line groups.
Program 17: Assigns immediate or wink start, camp on over tie lines, paging over tie lines.
Important!
Also used to turn on the tie line dial tone return.
Note When a PACU is installed in a system, it automatically assumes the next four
consecutive exchange line numbers.
Program 39: Assigns line access buttons to digital and electronic telephones.
Program 40: Assigns station access to tie lines (incoming & outgoing).
Program 41: Assigns station access to the lines (outgoing).
Programs 48 & *48: Assigns the level of Toll Restriction to the Tie Line Groups.
Program *53: Assigns outgoing digit translation.
Program *54: Assigns incoming digit translation.
Programs 50~56: Assigns LCR, if using the network as a route operation.
Program 81-83: Tie line ringing assignments.
Program 93: Assigns a name to a tie line
Universal Slot PCBs
3-27