Toshiba strata CT Installation & Maintenance Manual page 331

Table 10-3
Switches/Jumpers/Connector
SW2 (Reset switch)
J1 8-pin Modular Connector (RJ45)
J2 6-pin Modular Connector (RJ11)
1.
If this switch on the Primary Clock source RPTU is pressed (Program *42-1), the clock source will automatically revert
to the Secondary Clock source PCB (Program *42-2 and Program *42-1 will have to be reprogrammed.)
H
C
Figure 10-1
Strata CT I&M Manual October 2000
Note For cabling information and requirements, refer to
RPTU Switches, Jumpers and Connectors
1
SW2
J2
RS-232C
FSYC
AIS
RAB
LOS
RST
BSU
TS
LEDs
J1
ISDN (PRI)
RPTU1A
RPTU PCB
Resets or initialises the RPTU firmware. Press this switch to correct an
out-of-service condition, or just prior to connecting to the Network PRI.
Connects the RPTU to the PRI ISDN line.
Connects the RPTU to a terminal or PC to monitor D-channel data.
RPTU1A
(front)
V .1
2543 CT I&M
ISDN Interfaces
"Cabling" on Page
Description
10-7.
10-5