Voice Mail Program Checklist - Toshiba strata CT Installation & Maintenance Manual

Peripheral Installation
Receive Auto Call Forward ID Codes
Provides auto digits from call forwarded stations to direct callers to station mailboxes. All
VM ports should be set to receive auto ID code (Program 31, LED 16).

Voice Mail Program Checklist

Prior to Programming
See Toshiba Stratagy Voice Processing documentation for other parameter settings.
Programming Strata CT for Voice Mail
N
N
N
N
H
N
N
C
N
N
N
Note
N
N
N
6-44
Program 92: Initialisation clears voice mail auto dial codes.
Program 03: Verifies that a BRCS is installed to enable the VM device to send DTMF
tones. Also sets PIOU, PIOUS (code 43) or RSIU/RSIS (code 49) to enable the SMDI
port (see Program 76 if installing RSIU or RSIS SMDI port).
Program 04: Assigns station Intercom or Directory numbers [DN] to VM ports
(initialised numbers recommended).
Program 05: First digit of special codes #63 and #64 (initialised numbers
recommended).
Program 10-1: If the system is first set for voice, program the VM device to dial the
suffix "1" after station numbers.
Program 10-2: If LED 04 On for set/cancel operation and LED 06 On for the VM to
detect 80 millisecond tones. Also set DTMF Tone return or No DTMF return options
(LED 11 and 20).
Program 10-3: Sets SMDI options.
Program 13: If the VM device is the message centre, set the lowest standard telephone
port in the Program 31 VM group as the message centre.
Program 31: Turn LEDs 04, and 15~20 On, and LED 05, 06, 07 or 08 On for the PSTU/
RSTU, ports that are connected to the Toshiba Stratagy VM ports. Turn LED 09 On for
VM Auto Attendant "Supervised Transfer" operation; turn LED 09 Off for VM Auto
Attendant "blind transfer" operation and/or VM two Exchange-line tandem connection.
Do not set these options for telephone station ports.
A, D, and B Tones should be enabled only for VM devices that respond to these
tones.
Program *32: Sets lowest standard telephone port if the Program 31 VM group as
message centre for stations using VM.
Program 33: Sets the PSTU/RSTU, ports that are connected to the VM ports to a
hunting sequence, starting with the lowest port hunting to the next highest port, etc. The
last hunt should be to an attendant station. Only use Program 33 if you ar not using
Program *40 to set up a VMDM group.
Program *34: Turns Off LED 01 to disable camp-on BOV tone to a VM port.
Strata CT I&M Manual October 2000