Dkt2001 Digital Single Line Telephone - Toshiba strata CT Installation & Maintenance Manual

DKT2001 Digital Single Line Telephone

H
➤
To wall mount DKT2001 digital SLTs
C
Figure 5-5
Strata CT I&M Manual October 2000
The following provides information on how to
connect the DKT2001 Digital Single Line
Telephones (SLTs) to the CT system.
Before proceeding, see warning and caution notes in
"Telephone Installation" on Page
The digital SLTs connect to the digital telephone
ports via the MDF with standard twisted-pair
jacketed telephone cable. If using CW1308 cable,
single-pair wiring is sufficient in most cases for
DKT2001 model standard telephones to operate
effectively at up to 305 metres from the system.
To accommodate the digital telephone line cord, the
cable should be terminated in a slave LJU at the
station location. The standard single-pair, modular
DKT2001 model standard telephone cord that is sent
with the telephone is 3 metres. (the maximum
allowed is 10 metres.).
Digital telephone cable runs must not have cable splits (single or double), cable bridges (of
any length), or high resistance or faulty cable splices.
Handset Hanger
Removing the Telephone Base
1. Loosen the screws, and remove the telephone base.
2. Using a suitable cutter, remove the handset hanger from the base.
3. Insert the handset hanger in the slot on the front of the phone. The hanger fits in the
notch on the handset cradle.
4. Rotate the telephone base 180 degrees and secure it to the telephone with its four
screws.
5. Connect the phone to the wall modular connector with a cord approximately four inches
long (available at most telephone supply companies).
5-3.
Plastic Tab
1478
Station Apparatus
5-9