Toshiba strata CT Installation & Maintenance Manual page 67

Figure 2-19
H
C
Strata CT I&M Manual October 2000
7. Install the bolt anchors with plugs in the drilled holes.
Bottom
Cabinet
BFIF
(Floor
mount
fixture)
Floor Tiles
Flat Washer
Lock Washer
Lead Anchors
Hex Nut
Concrete
Installation on Computer Room Floor
8. Using the driving tool and a hammer, drive each bolt anchor into the floor.
9. Screw threaded rods into each bolt anchor.
10. Install a hex nut, lock washer, and flat washer on each threaded rod. Screw the nuts
down far enough to allow floor tiles to be replaced over the threaded rods.
11. Replace tiles over threaded rods in their original positions on the floor.
12. Reach under the tiles, and screw the hex nuts upward until the flat washers are touching
the bottom of the tile.
13. Use a hack saw to cut the threaded rods at a height of approximately 1.5 inches above
the floor tile.
14. Move the Base Cabinet into position over the threaded rods.
15. Secure the Base Cabinet to the floor using flat washers, lock washer, and hex nuts on
each threaded rod.Mount Cabinets to Computer Room Floor (Unbolted)
16. Make sure that cabinet power supplies (BPSU672A) are installed per
Supply" on Page 2-6.
17. Remove front, side, and top covers from all cabinets
Note
As shown in Figure
the front cover (the bottom left screw must be completely removed) should only be
loosened and the covers slid to the right for removal.
18. Remove plastic locating parts from all cabinet back covers using a Phillips screwdriver
(Figure 2-3).
19. Install a floor fixture (BFIF) on each side of the bottom cabinet
making sure that the fixture is inside of the cabinet edge.
20. Secure a wall bracket (RWBF) to both floor fixtures with the screws provided. Secure
the wall brackets to the wall with customer-provided wood screws and wall anchors.
21. Place a cabinet on top of the bottom cabinet and connect the cabinets together at points
"A" and "B"17 with the screws provided.
22. Install wall brackets (RWBF) on the top of cabinet three and secure them to the wall
with customer-provided wood screws and wall anchors.
1469
2-4, the two screws on each side cover and the three screws on
Strata CT Installation
"Install Power
(Figure 2-4).
(Figures 2-15 and 2-19),
2-31