Smdr Programming; Smdr Printer/Call Accounting Device Installation - Toshiba strata CT Installation & Maintenance Manual

SMDR Programming

Program 03
Program 60
H
C
Program 76

SMDR Printer/Call Accounting Device Installation

Strata CT I&M Manual October 2000
N
The SMDR output is provided by the PIOU or PIOUS with the lowest code assigned
(41, 42, or 43).
N
If using RSIU or RSIS PCB in slot 11 for SMDR, set Program 03 code 49 for slot 11.
Notes
RSIU/RSIS Program 76-1 code x2 overrides PIOU/PIOUS SMDR assignments and
G
code 49 for RSIU/RSIS.
N
Item 1: Selects Caller ID, DDI or Account Code to be sent out the SMDR Port.
N
Item 2: Selects the minimum duration (1.0 or 10 seconds) of calls that will be registered
by SMDR. Any call that lasts less than the set time will not be recorded.
N
Item 3: Selects the records of outgoing calls or outgoing and incoming calls to be
printed.
N
Item 4: Selects the digit length of Account Codes (4 to 15 digits).
N
Item 5: Allows only long distance call records to be printed.
N
Item 6: DISA security code.
N
Item 7: Credit card calling digit length.
N
RSIU/RSIS is used to interface to the SMDR device use Program 76 to make the
appropriate RSIU/RSIS SMDR programming assignments.
1. Connect the interface cable and the TTY-PC-CABLE or PPTC1A-3M adapter from
thePIOU, PIOUS, RSIU/RSIS, or SMDR port to the SMDR printer or call accounting
device DB25 or DB9 connector.
TTY and SMDR Wiring in
2. Set the PIOU or PIOUS SW1 switch to the appropriate bps rate – 1200~9600 bps),
(PIOU/PIOUS – 300 or 1200 bps, RSIU/RSIS as determined by the baud rate of the
printer or call accounting device (Program 76 set RSIU/RSIS bps rate).
3. Set the printer or call accounting device to no parity/8-bits/one stop bit.
4. Use Program 60 to set the system for the required SMDR printer/call accounting device
options (See the following section and the Strata CT Programming Manual).
Note Only the PIOU/PIOUS with the lowest code in Program 03 (41, 42, or 43) or RSIU/
RSIS with Program 76-1 code X2 will provide the SMDR output.
(See Figure 6-21 and PIOU, PIOUS, RSIU, or RSIS
Chapter 4 – Universal Slot PCB Wiring
Peripheral Installation
for more details.)
6-39