Bvpu Programming - Toshiba strata CT Installation & Maintenance Manual

Universal Slot PCBs
Figure 3-1
H

BVPU Programming

Note
C
N
N
N
N
N
Important!
Note
N
N
N
N
3-4
BVPU
Monitor jack
RD
TD
DSR
DTR
DCD
SG
5243
BVPU Monitor Jack
For programming purposes, the Strata CT regards the BVPU card as a PEMU or
PACU and identifies it as such. Programming instructions for the gateway
component are included in the Voice Over IP Installation Guide.
Program 03: Specify Code 13 for slots that support PEMUs or REMUs (BVPUs) and
make sure RRCS is enabled for DTMF operation.
Program 04: Specifies [PDNs]. These are also the numbers that must be received by
incoming Tie lines to route calls to the proper telephones.
Program 10-1: Enables/disables two-line conference.
Program 15: Assigns tandem connections and dial pulse option to Tie lines.
Program 17: Assigns immediate or wink start to BVPU Tie lines.
Also used to turn on Tie line dial tone return.
When a BVPU is installed in a system, it automatically assumes the next four
consecutive Exchange line port numbers.
Program 30: Disables BRCS for dial pulse operation.
Program 71 (1~5) and Program 72: Tie/DDI assignments.
Program *71~*73: DH/Tie/DDI to [DN] ringing assignments.
Program 93: Assigns a name to a Tie line
PC with maintenance
console software
PC DB9 or
DB25 Com port
Toshiba TTY - PC - Cable
1
2
3
4
5
6
Call-monitor jack (RJ12)
pin numbering
Strata CT I&M Manual October 2000