Toshiba strata CT Installation & Maintenance Manual page 230

Peripheral Installation
For installation procedures, see:
N
H
Figure 6-23
Toshiba Stratagy Programming
C
Some features of Strata CT system programming were designed for Toshiba Stratagy or
Stratagy DK systems, and do not necessarily apply to customer-supplied voice mail
messaging systems. These programming features are:
Answer (A) Tone
The Strata CT stations send an answer tone to Stratagy when the station answers a Stratagy
call.
Disconnect (D) Tone
The Strata CT stations send a disconnect tone to Stratagy when the station hangs up while
connected to Stratagy. (D Tone is also sent to release the Stratagy Auto Attendant port when
an outside Exchange line caller hangs-up and the Exchange provides a Calling Party Control
(CPC) or Auto Release (AR) disconnect signal per Program 15-0 and 15-3).
Notes
6-42
Chapter 3 – Universal Slot PCBs
Processor
RRCS 4, 8, or 12
PSTU/RSTU3
(CKT 1~8)
25-Pin Cable
(8 circuits per PSTU/RSTU)
Voice Mail Block Diagram
D Tone will not operate in all areas, because some Exchanges fail to provide the
G
CPC or AR signal on loop start lines.
Both A and D Tones provide more efficient Stratagy port use. Always enable these
G
options. Both options are enabled by accessing Program 31, and setting LED 15 On.
The CPC or AR signal of some Exchanges is not reliable and may occur during a
G
Exchange line voice connection, causing the call to disconnect. If this occurs,
disable CPC /AR Hold and CPC/AR for Voice Mail calls on all Exchange lines with
Programs 15-0 and 15-3.
for PSTU and RSTU
Voice Mail
Machine
MDF
Standard Telephone
Circuit Tip & Ring
(1 Pair PerVM Port)
Strata CT I&M Manual October 2000
4306