Rptu Performance Monitoring - Toshiba strata CT Installation & Maintenance Manual

ISDN Interfaces

RPTU Performance Monitoring

The performance of the RPTU can be monitored using the Data Dump Mode. This requires:
N
N
N
The RPTU monitoring feature provides a download of PRI errors detected as shown in
Figure
communications software.
There are no time parameters for the error report, so the time between error-count increments
must be monitored manually. The counter is reset after 15 registrations and begins again from
zero. Basically the error count of any error category should not increase within 24-hour
periods.
➤
To dump the data (PRI ERROR DISPLAY) from a terminal or PC (local or remote)
1.
2.
3.
H
4.
➤
To exit the dump mode
C ➤
10-24
RSIU, RSIS, PIOU, PIOUS or TSIU PCB TTY port.
ASCII terminal or PC with communications software (such as ProComm or
Hyperterminal).
IMDU or RMDS modem or Hayes compatible modem for remote monitoring.
10-18. This data can be stored to a file and/or printed when using a PC with
Establish communications between the CT TTY port and the terminal or PC using a
communications software.
Enter the security code, and press Enter (or Return).
At the >MODE prompt, type DUMP (must be all caps), and press Enter (or Return).
The >D prompt displays on your screen.
At the >D prompt, type PRIERR and press Enter (or Return). The display (see
Figure 10-18) shows all RPTU PCBs (PRI NO=1~PRI NO=8), even if the associated
RPTU (1~8) is not installed. The ERROR counter can only be reset by turning the CT
Off and On.
At the >D prompt, type QUIT, press Enter (or Return); the >MODE prompt
displays.
Strata CT I&M Manual October 2000