Adding An Ip Gateway - Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
Figure 41: IP Gateways Table
If IP gateways have not been configured, add IP gateways as needed. For more information, refer to
Section 3.8.2, "Adding an IP Gateway"
Section 3.8.2

Adding an IP Gateway

To add an IP gateway, do the following:
Navigate to Administration » Configure IP Gateways . The IP Gateways table appears.
1.
1
Figure 42: IP Gateways Table
1. InsertRecord
2. Click InsertRecord. The IP Gateways form appears.
Adding an IP Gateway
.
Chapter 3
Device Management
89