Viewing Forwarding Information For Multicast Groups - Siemens RUGGEDCOM ROS v4.3 User Manual

Chapter 5
Setup and Configuration
If the table is empty, do the following:
• Make sure traffic is being sent to the device.
• Make sure IGMP is properly configured on the device. For more information, refer to
"Configuring IGMP"
Section 5.8.1.3

Viewing Forwarding Information for Multicast Groups

Multicast forwarding information for every source, group and VLAN combination learned by RUGGEDCOM ROS is
recorded in the IGMP Multicast Forwarding table.
To view the IGMP Multicast Forwarding table, navigate to Multicast Filtering » View IGMP Multicast
Forwarding . The IGMP Multicast Forwarding table appears.
Figure 153: IGMP Multicast Forwarding Table
This table provides the following information:
Parameter
VID
Group
Source
Joined Ports
Router Ports
If the table is empty, do the following:
• Make sure traffic is being sent to the device.
• Make sure IGMP is properly configured on the device. For more information, refer to
"Configuring IGMP"
222
.
.
Description
Synopsis: 0 to 65535
VLAN Identifier of the VLAN upon which the multicast group
operates.
Synopsis: ###.###.###.### where ### ranges from 0 to 255
Multicast Group Address.
Synopsis: ###.###.###.### where ### ranges from 0 to 255 or
{ * }
Source Address. * means all possible source addresses.
Synopsis: Comma-separated list of ports
All ports that currently receive multicast traffic for the specified
multicast group.
Synopsis: Comma-separated list of ports
All ports that have been manually configured or dynamically
discovered (by observing router specific traffic) as ports that link to
multicast routers.
Viewing Forwarding Information for Multicast Groups
RUGGEDCOM ROS
User Guide
Section 5.8.1.4,
Section 5.8.1.4,