Viewing And Clearing Latched Alarms; Configuring An Alarm - Siemens RUGGEDCOM ROS v4.3 User Manual

Chapter 4
System Administration
NOTE
This list of alarms (configurable and non-configurable) is accessible through the Command Line
Interface (CLI) using the alarms. For more information, refer to
Commands"
For information about modifying a pre-configured alarm, refer to
Section 4.6.2

Viewing and Clearing Latched Alarms

To view a list of alarms that are configured to latch, navigate to Diagnostics » View Latched Alarms . The
Latched Alarms table appears.
Figure 67: Latched Alarms Table
To clear the passive alarms from the list, do the following:
1. Navigate to Diagnostics » Clear Latched Alarms . The Clear Latched Alarms form appears.
1
Figure 68: Clear Latched Alarms Form
1. Confirm Button
Click Confirm.
2.
Section 4.6.3

Configuring an Alarm

While all alarms are pre-configured on the device, some alarms can be modified to suit the application. This
includes enabling/disabling certain features and changing the refresh time.
To configuring an alarm, do the following:
118
.
Section 2.6.1, "Available CLI
Section 4.6.3, "Configuring an Alarm"
Viewing and Clearing Latched Alarms
RUGGEDCOM ROS
User Guide
.