Deleting A Static Mac Address - Siemens RUGGEDCOM ROS v4.3 User Manual

Chapter 5
Setup and Configuration
Parameter
Port
CoS
4. Click Apply.
Section 5.4.4.3

Deleting a Static MAC Address

To delete a static MAC address from the Static MAC Address Table, do the following:
Navigate to MAC Address Tables » Configure Static MAC Addresses . The Static MAC Addresses table
1.
appears.
Figure 121: Static MAC Addresses Table
2. Select the MAC address from the table. The Static MAC Addresses form appears.
192
Description
VLAN Identifier of the VLAN upon which the MAC address
operates.
Option ANY allows learning a MAC address through the Port
Security module on any VLAN's that are configured on the switch.
Synopsis: 1 to maximum port number or { Learn }
Default: Learn
Enter the port number upon which the device with this address is
located. The security mode of the port being selected should not
be '802.1X'.
If the port should be auto-learned, set this parameter to 'Learn'.
The option 'Learn' is applicable for Port Security in 'Static MAC'
mode.
Synopsis: { N/A, Normal, Medium, High, Crit }
Default: N/A
Prioritizes traffic for the specified MAC address. To not prioritize
traffic based on the address, select N/A.
RUGGEDCOM ROS
User Guide
Deleting a Static MAC Address