Adding An Snmp User - Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
Figure 128: SNMP Users Table
If users have not been configured, add users as needed. For more information, refer to
an SNMP User" .
Section 5.6.1.2

Adding an SNMP User

Multiple users (up to a maximum of 32) can be configured for the local SNMPv3 engine, as well as SNMPv1 and
SNMPv2c communities.
NOTE
When employing the SNMPv1 or SNMPv2c security level, the User Name parameter maps the
community name with the security group and access level.
To add a new SNMP user, do the following:
1. Navigate to Administration » Configure SNMP » Configure SNMP Users . The SNMP Users table appears.
1
Figure 129: SNMP Users Table
1. InsertRecord
2. Click InsertRecord. The SNMP Users form appears.
Adding an SNMP User
Chapter 5
Setup and Configuration
Section 5.6.1.2, "Adding
199