Managing Security-To-Group Mapping; Viewing A List Of Security-To-Group Maps; Adding A Security-To-Group Map - Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
Section 5.6.2

Managing Security-to-Group Mapping

The following section describes how to configure and manage security-to-group maps.
CONTENTS
• Section 5.6.2.1, "Viewing a List of Security-to-Group Maps"
• Section 5.6.2.2, "Adding a Security-to-Group Map"
• Section 5.6.2.3, "Deleting a Security-to-Group Map"
Section 5.6.2.1

Viewing a List of Security-to-Group Maps

To view a list of security-to-group maps configured on the device, navigate to Administration » Configure
SNMP » Configure SNMP Security to Group Maps . The SNMP Security to Group Maps table appears.
Figure 133: SNMP Security to Group Maps Table
If security-to-group maps have not been configured, add maps as needed. For more information, refer to
Section 5.6.2.2, "Adding a Security-to-Group Map"
Section 5.6.2.2

Adding a Security-to-Group Map

Multiple combinations of security models and groups can be mapped (up to a maximum of 32) for SNMP.
To add a security-to-group map, do the following:
Navigate to Administration » Configure SNMP » Configure SNMP Security to Group Maps . The SNMP
1.
Security to Group Maps table appears.
Managing Security-to-Group Mapping
.
Chapter 5
Setup and Configuration
203