Configuring Port Security - Siemens RUGGEDCOM ROS v4.3 User Manual

Chapter 5
Setup and Configuration
Parameter
MAC Address
VID
Sticky
If a MAC address is not listed, do the following:
• Configure port security. For more information, refer to
• Configure IEEE 802.1X. For more information, refer to
Section 5.9.3

Configuring Port Security

To configure port security, do the following:
Navigate to Network Access Control » Port Security » Configure Ports Security . The Ports Security table
1.
appears.
Figure 167: Ports Security Table
2. Select an Ethernet port. The Ports Security form appears.
236
Description
Synopsis: ##-##-##-##-##-## where ## ranges 0 to FF
Authorized MAC address learned by the switch.
Synopsis: 0 to 65535
VLAN Identifier of the VLAN upon which the MAC address operates.
Synopsis: { No, Yes }
This describes whether the authorized MAC address/Device can move
to another port or not:
• YES - authorized MAC address/Device cannot move to a different
switch port
• NO - authorized MAC address/Device may move to another switch
port
Section 5.9.3, "Configuring Port Security"
Section 5.9.4, "Configuring IEEE 802.1X"
RUGGEDCOM ROS
User Guide
.
.
Configuring Port Security