Configuring Stp Globally - Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
6. Configure the Port Cost and Priority per Port for each MSTI. For more information, refer to
"Configuring an MSTI for an Ethernet Port"
7. Set the STP Protocol Version to MSTP and enable STP. For more information, refer to

"Configuring STP Globally"

Section 5.2.4
Configuring STP Globally
To configure global settings for the Spanning Tree Protocol (STP), do the following:
Navigate to Spanning Tree » Configure Bridge RSTP Parameters . The Bridge RSTP Parameters form
1.
appears.
9
Figure 94: Bridge RSTP Parameters Form
1. State Options 2. Version Support List 3. Bridge Priority List 4. Hello Time Box 5. Max Age Time Box 6. Transmit Count
Box 7. Forward Delay Box 8. Max Hops Box 9. Apply Button 10. Reload Button
2. Configure the following parameter(s) as required:
Parameter
State
Version Support
Bridge Priority
Configuring STP Globally
.
Description
Synopsis: { Disabled, Enabled }
Default: Enabled
Enable STP/RSTP/MSTP for the bridge globally. Note that STP/RSTP/
MSTP is enabled on a port when it is enabled globally and along
with enabling per port setting.
Synopsis: { STP, RSTP, MSTP }
Default: RSTP
Selects the version of Spanning Tree Protocol to support, either
only STP or Rapid STP or Multiple STP.
Synopsis: { 0, 4096, 8192, 12288, 16384, 20480, 24576,
28672, 32768, 36864, 40960, 45056, 49152, 53248, 57344,
61440 }
Default: 32768
Chapter 5
Setup and Configuration
Section 5.2.9.5,
Section 5.2.4,
1
2
3
4
5
6
7
8
10
163