Viewing A Summary Of Multicast Groups; Configuring Gmrp Globally - Siemens RUGGEDCOM ROS v4.3 User Manual

RUGGEDCOM ROS
User Guide
• Switch C forwards the Group 2 multicast via Port C2, which has previously become a member of Group 2.
• Ultimately, Host H2, connected to Port C2, receives the Group 2 multicast.
Section 5.8.2.2

Viewing a Summary of Multicast Groups

To view a summary of all multicast groups, navigate to Multicast Filtering » View Multicast Group Summary .
The Multicast Group Summary table appears.
Figure 156: Multicast Group Summary Table
This table provides the following information:
Parameter
VID
MAC Address
Static Ports
GMRP Dynamic Ports
Section 5.8.2.3

Configuring GMRP Globally

To configure global settings for GMRP, do the following:
Navigate to Multicast Filtering » Configure Global GMRP Parameters . The Global GMRP Parameters form
1.
appears.
Viewing a Summary of Multicast Groups
Description
Synopsis: 0 to 65535
VLAN Identifier of the VLAN upon which the multicast group
operates.
Synopsis: ##-##-##-##-##-## where ## ranges 0 to FF
Multicast group MAC address.
Synopsis: Any combination of numbers valid for this parameter
Ports that joined this group statically through static configuration
in Static MAC Table and to which the multicast group traffic is
forwarded.
Synopsis: Any combination of numbers valid for this parameter
Ports that joined this group dynamically through GMRP Application
and to which the multicast group traffic is forwarded.
Chapter 5
Setup and Configuration
227