Setting Running Parameters (Special User) - Huawei SmartLogger2000 User Manual

SmartLogger2000
User Manual
No. Parameter
32 Commanded
shutdown hold
after power
recovery
33 String
connection
mode
34 PID protection
at night
35 RS485-2
communication

7.8.3.3 Setting Running Parameters (Special User)

Settings Page
Because of permission restriction, log in to the WebUI as a special user. Choose
Monitoring > SUN2000 > Running Param. to access the setting page.
Issue 04 (2018-04-10)
Description
The standards of certain
countries and regions
require that the inverter
remains in the
commanded shutdown
state after being powered
off by a command and
experiencing a power
failure and recovery.
Sets the connection mode
of PV strings.
When the inverter outputs
reactive power at night
and this parameter is set
to Enable, the inverter
will shut down
automatically if it detects
abnormal status of the
PID compensation during
the time.
If this parameter is set to
Enable, the RS485-2 port
can be used. If it is not
used, it is recommended
that this parameter be set
to Disable to reduce
power consumption.
Before setting the running parameters of the inverter, ensure that the DC side is energized.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Unit Value Range
N/A  Disable

Enable
N/A  Automatic
detection
 All PV
strings
separated
 All PV
strings
connected
N/A  Disable
 Enable
N/A  Disable
 Enable
7 WebUI
Remarks
N/A
N/A
N/A
N/A
108