Huawei 5288 V3 V100R003 User Manual page 259

5288 V3 Server
User Guide
l
l
Logging In over SSH
The SSH protocol is used to provide secure remote login and other network services on an
insecure network. A maximum of five users can log in over SSH simultaneously.
To log in to the CLI over SSH, perform the following operations:
l
l
Logging In over Telnet
Telnet is insecure and is disabled by default. To log in to iBMC over Telnet, enable the Telnet
service by choosing Config > Service Settings on the iBMC WebUI.
To log in to the iBMC CLI over Telnet, perform the following operations:
l
l
Issue 26 (2018-11-19)
IP address of the iBMC management network port
User name and password of the iBMC management network port
The default iBMC user name is root, and the default password is Huawei12#$.
NOTE
SSH is used by default to log in to iBMC. If the SSH service is disabled, enable it by choosing Config >
Service Settings on the iBMC web user interface (WebUI).
In Linux
a. Connect the network port of the configuration terminal to the management network
port of the server.
b. Run the following command in the terminal tool to log in to the iBMC CLI:
ssh ipaddress
In Windows
a. Download and install the client communications tool that supports SSH.
b. Connect the network port of the configuration terminal to the management network
port of the server.
c. Enter the user name, password, and IP address of the management network port on
the client communications tool to log in to the iBMC CLI.
NOTE
iBMC 2.20 and later do not support CLI login over Telnet.
In Linux
a. Connect the network port of the configuration terminal to the management network
port of the server.
b. Run the following command in the terminal tool to log in to the iBMC CLI:
telnet ipaddress
In Windows
a. Connect the network port of the configuration terminal to the management network
port of the server.
b. Run the following command in the terminal tool to log in to the iBMC CLI:
telnet ipaddress
Copyright © Huawei Technologies Co., Ltd.
9 Common Operations
249