Huawei 5288 V3 V100R003 User Manual page 27

5288 V3 Server
User Guide
Silk Screen
-
-
Issue 26 (2018-11-19)
Meaning
UID button/
indicator
Health indicator
Hard disk
activity indicator
Hard disk fault
indicator
Network port
link status
indicators
Copyright © Huawei Technologies Co., Ltd.
State Description
The UID button/indicator helps identify and
locate a server in a rack. You can turn on or off
the UID indicator by manually pressing the UID
button or remotely running a command on the
iBMC CLI.
l Off: The server is not located.
l Steady blue: The server is located.
NOTE
l You can press this button to turn on or off the UID
indicator.
l You can press and hold down this button for 4 to 6
seconds to reset the iBMC.
l Steady green: The server is operating properly.
l Blinking red at 1 Hz: A major alarm is
generated.
l Blinking red at 5 Hz: A critical alarm is
generated.
l Off: The hard disk is not detected or is faulty.
l Blinking green: Data is being read from or
written to the hard disk, or synchronized
between hard disks.
l Steady green: The hard disk is inactive.
l Off: The hard disk is working properly.
l Blinking yellow: The hard disk is located, or
rebuilding RAID.
l Steady yellow: The hard disk is faulty, or hard
disk members of the RAID array the hard disk
is in are abnormal.
NOTE
If the fault indicator is steady yellow, run related
commands to check the RAID status to determine
whether the RAID array status is abnormal or whether
the hard disk is faulty. For details about command
description, see HUAWEI V2&V3 Server RAID
Controller Card User Guide.
The indicators show the status of each Ethernet
port on the flexible NIC.
l Off: The port is not in use or faulty.
l Steady green: The port is properly connected.
NOTE
If the flexible NIC provides two network ports, they
correspond to network port indicators 1 and 2 on the
front panel.
2 Product Overview
17