Panasonic LP-400 Series External Control Manual page 112

⿎ DXF logo condition : CDD
Sets the marking condition of DXF logo file.
• Setting / Readout data of DXF logo condition
Sub
STX CDD
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.
• Readout request of DXF logo condition
STX CDD R
Name
Logo No.
Area No.
Origin position
X position
Y position
Rotation angle
Size specification
Width
Height
Font
Marking pitch
Marking direction
112
[Logo No.] [Area No.] [Origin position] [X position] [Y position]
[Rotation angle] [Size specification] [Width] [Height] [Font]
[Marking pitch] [Marking direction] [Laser power correction]
[Scan speed correction] [Laser pulse cycle correction]
Max. 58-byte (LP-V series), Max. 55-byte (LP-400/LP-W series)
[Logo No.]
2-byte
Data
length Content
[byte]
2 "00"–"15"
1 "0"–"9", "A"–"F"
"0": Center
"1": Left bottom
"2": Right bottom
1
"3": Left top
"4": Right top
"5": Original graphic
8
"-300.000"–"+300.000" [mm]
8
7 "-180.00"–"+180.00" [° ]
"0": Height/Width
"1": Width
1
"2": Height (width fixed)
"3": As original graphic size
Model type*
(7)
LP-V10
LP-4x0
LP-4x5/LP-V15
(7)
LP-4x1/LP-W
"1": Character font 1
1
"2": Character font 2
5 "0.010"–"2.000"
"0": Lateral
1
"1": Longitudinal
ME-LP400V-EX-6
(Check sum) Delimiter
Setting range [mm]
"000.100"–"090.000"
"000.100"–"110.000"
"000.100"–"160.000"
"000.100"–"055.000"
(Check
sum)
Remarks
Specifies which area part is the
marking position of the concatenated
marking on the flying object.
In case of marking static object, specify
"0".
Specifies the origin coordinate of the
logo.
Available only "0": Height/Width
or "1": Width is specified at "Size
specification".
Available only "0": Height/Width
or "2": Height is specified at "Size
specification".
Sets font of logo file data.
Delimiter