Panasonic LP-400 Series External Control Manual page 155

ERROR
CODE
E606 Existed marking data outside of marking area.
E607 Cannot create bolded character.
Lack of marking memory.
E610
• Marking data is too large.
E612
• The line length is too long. (spiral, etc.)
E620 Flying object area over.
E621 (Can not follow line speed of flying object marking.)
Flying object time over.
E622
(Can not follow line speed of flying object marking.)
Too narrow marking interval for proportioned flying
E623
object.
E630 Too much quantity of Step and Repeat marking.
Error details
ME-LP400V-EX-6
Measures
Contain marking data within marking area.
• Change marking position.
• Make characters smaller.
• Narrow character interval.
* If there is no data out of the marking field in the
image display, check the "system offset" in the
environment setting.
"System offset" value is not shown in the image
display.
• Set any standard font without original 4 font.
• Use Font Maker provided to create the proper
pattern font.
• Set line width of bold character to quarter or below
of character height and width.
• When marking the bold character, set the
comparison ratio between character height and
width become 1/4 to 4.
• Check the line width of bold character not exceed
the specified value.
• Reduce numbers of characters and logo data.
• Reduce numbers of step & repeat.
• Reduce numbers of a start point and a end point
of characters or logo data.
• Separate the long segment into short data.
• Shorten marking time with the following methods.
• Speed up scan speed.
• Narrow character interval.
• Make characters smaller.
• Reduce numbers of characters.
• Change setting of curve/edge.
• Reduce numbers of character lines.
• Displace a start point of marking, etc.
• Adjust the line speed of the flying object.
• Adjust the waiting time of the flying object.
• Set the coordinate of the marking data close to the
center of the marking field.
Increase setting value of marking spacing. Shorten
marking time with the following methods.
• Speed up scan speed.
• Narrow character interval.
• Make characters smaller.
• Reduce numbers of characters.
• Change setting of curve/edge.
• Reduce numbers of character lines.
• Set smaller value to the one-shot output time, etc.
Reduce numbers of characters to be marked. (Max.:
1000)
155