Communication Condition Setting - Panasonic LP-400 Series External Control Manual

1-3-2 Communication condition setting

To control the laser marker by using I/O or communication commands, configure the following items in advance on the
environment setting screen.
1.
Select "ENVIRON" on the right menu.
2.
Select "ENVIRON 3".
3.
To use I/O signals, configure the following output conditions:
• One-shot time:
Sets the output duration for some signals such as MARK END OUT and SET OK OUT.
Setting range: 2 ms to 510 ms (initial value is 40 ms)
• Detect TRIG. Warning during Marking
Configure if you will output (ON) or will not output (OFF) the warning for the invalid trigger. With enabling this setting,
the warning is output when the marking trigger that cannot be accepted was input while the shutter is opened.
• I/O Connector Setting
Select the operation of I/O connector signal No. 35 from "Output Counter 3 End" or "Output Date Difference".
ME-LP400V-EX-6
21