ABB 2Line Manual page 45

TURNING ON THE AUTO SWITCH-ON SYSTEM
Push the auto switch-on button (8). You can see the image captured by the video unit in the
entrance panel, open the door and communicate with the entrance panel by simply picking
up the handset of the monitor.
If some monitor is activated, the system indicator (5) will start blinking when pressing the
auto-switch button (8) and the auto switch-on function will not operate. I f the handset is
picked up, busy tones will be heard . In this event wait until the system becomes free.
5
Time of
Time of
auto switch-on
auto switch-on:
Maximum time limit:
60 seconds (1)
30 seconds (1)
8
Flat
Auto switch-on
The calls from the entrance panel have priority over the auto switch-on system. If a call is
made from the entrance panel during the time of auto switch-on, the video of your monitor
will switch off, and the monitor will change to stand by status automatically, ensuring the
privacy of the call.
In installations with several points of entry, press the auto switch-on button (8) repeatedly until
the desired entrance panel is activated.
8 8
8
(1) The values shown may vary depending on the installation.
Consult your installer
43 | ABB