Motorola KEY 3000 User Manual page 49

Perform Initial
Programming
(continued)
ASN Operation
Chapter 3 Performing Initial Programming
User Preference Parameters
(continued)
3. Enter the desired Supervisor password.
The password must contain 6 characters
using any of the keypad buttons 0 thru F.
When finished, press the Enter key.
4. Repeat for the Operator password. The
following screen
password entries.
KVL 3000 is powered up, a password will
be required before operating the unit.
PASSWORDS
READY
EDIT
Important Note If the Supervisor password is
forgotten, a reset (see page 8-10) must be
performed before the KVL 3000 can be used
again. Because a reset erases all stored keys
and returns the KVL 3000 settings to the factory
defaults, you are strongly encouraged not to
forget your password.
If the Operator password is forgotten, the
Supervisor can simply assign a new Operator
password (overwriting the old password).
will confirm your
Whenever the
ERASE
3-13