Attended Recovery; Hardware Requirements - HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual

Error Recovery

Attended Recovery

For attended recovery, ASR-2 executes the following functions:
NOTE: This feature is only available on servers that use the System Configuration Utility.
Attended recovery is not available on systems that use RBSU.
•
Logs the error information to the IML
•
Resets the server
•
Initiates Diagnostics from the hard drive
•
Enables remote access:
— If you have configured for dial-in access and have a modem with an
auto-answer feature installed, you can dial in and remotely diagnose or
reconfigure the server.
— If you have configured the Diagnostics for network access, you can access
the utilities over the network. Use Insight Manager for either dial-in or
network access.

Hardware Requirements

To obtain full utilization of ASR-2 over a modem, you need the following:
•
A non-PCI Hayes-compatible modem
•
Diagnostics installed on the system partition of the hard drive
•
ASR-2 configured to load Diagnostics after restart
You can also run Diagnostics remotely over an Internetwork Packet Exchange (IPX)
or Internet Protocol (IP) network using the Network feature.
•
To use Diagnostics on an IPX network, you must have Insight Manager 2.0 or
later, or a Novell Virtual Terminal (NVT) terminal emulator with VT100 or
American National Standards Institute (ANSI) terminal capabilities.
•
To use Diagnostics on an IP network, you must have Insight Manager 2.10 or
later, or a Telnet terminal emulator with VT100 or ANSI capabilities.
5-6 HP Servers Troubleshooting Guide