HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual page 184

POST Error Messages
Table C-2: Non-Numeric Error Messages or Beeps Only
Error Code
ECC Multiple Bit Error
Detected in DIMM X
ECC Multiple Bit Error
Detected in
DIMM/SIMM pair:
DIMM X
FATAL ROM ERROR:
The System ROM is
not properly
programmed.
Fixed Disk Parameter
Table or BIOS Error
System Halted
Initialization failure.
Re-seat the processor
and Processor Power
Module before
attempting
replacement
Invalid electronic
serial number
Loss of Nonvolatile
Configuration Memory
Network server mode
active and no
keyboard attached
C-4
Audible Probable Source of
Beeps Problem
None A memory module failure
generated a multiple bit
error that could not be
corrected.
None A memory module failure
generated a multiple-bit
error that could not be
corrected.
1 long, The System ROM is not
1 short properly programmed.
None An error occurred while
attempting to
communicate with the
CD-ROM/diskette drive
assembly. This assembly
may not be seated
properly.
None Processor was not fully
seated.
A processor internal
failure occurred.
None Serial number in BIOS is
incorrect.
None Nonvolatile memory has
been corrupted or
cleared.
None This is not an error but
simply displays when
keyboard is not
connected.
continued
Action
Run Diagnostics and replace
failed memory module as
indicated.
Run Diagnostics and replace
failed memory module as
indicated.
Replace the physical ROM
part.
1. Reseat the
CD-ROM/diskette drive
assembly.
2. Check the media
currently in the drive.
1. Reseat the processor.
2. Replace the processor if
the failure recurs.
Run the server setup utility to
program serial number.
No action needed. System will
automatically load default
nonvolatile configuration.
No action required.
HP Servers Troubleshooting Guide
continued