HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual page 241

Table C-13: 1700 Series POST Error Messages
Error Code
1779-Slot X Drive
Array – Replacement
drive(s) detected OR
previously failed
drive(s) now
operational:
Port Y: SCSI ID Z:
Restore data from
backup if replacement
drive X has been
installed.
1780-Disk 0 Failure
1781-Disk 1 Failure
1782-Disk Controller
Failure
HP Servers Troubleshooting Guide
Audible Probable Source of
Beeps Problem
None More drives were failed
(or were replaced) than
the fault-tolerance level
allows. Unable to rebuild
array.
None Hard drive/format error
detected. The drive is not
installed correctly or has
failed.
None Hard drive/format error
detected.
None Hard disk drive circuitry
error detected.
continued
Action
If this message is displayed
and drives have not been
replaced, this indicates an
intermittent drive failure. Be
sure that the system is always
powered up and down
correctly.
•
When powering up the
system, all external
storage systems must be
turned on before (or at
the same time as) the
server.
•
When powering down the
system, the server must
be powered down before
powering down any
external storage systems.
Be sure that any jumpers are
set correctly, and that power
and drive cables are
connected, both to the drive
and the system board. Also
be sure that the cables are
the correct cables for your
computer model. Run
Diagnostics. Replace failed
assembly as indicated.
Run Diagnostics. Replace
failed assembly as indicated.
Run Diagnostics. Replace
failed assembly as indicated.
POST Error Messages
continued
C-61