HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual page 279

Index
UPS, warning 2-8
batteries less than 75% at
sufficient charge D-10
battery pack X below reference
voltage D-11
battery pack X below reference
voltage, array
accelerator D-5
battery pack X not fully
charged, array
accelerator D-5
baud rate, setting 2-46
beeps, not heard during POST 2-37
BIOS Serial Console 4-18
BIOS Setup Utility A-6
blank screen 2-35, 2-36
blanking panels 2-27
board in use by expand
operation D-5
board not attached D-5
boot, defined xii
booting problems 1-6, 1-7, 1-8, 1-9, 1-10,
1-11, 1-12, 1-13, 1-14, 2-5, 2-6, 2-7,
2-8, 2-9, 2-10, 2-11, 2-12, 2-16
bootstrap processor is not the
lowest stepping processor
in the system C-32
brownout, defined 6-8
bus, SCSI See SCSI bus
C
cables
connections, network problems 2-42
damage, preventing 6-12
drives, ADU error messages D-7, D-11,
D-12, D-13, D-15, D-19, D-20, D-21
rack considerations 2-38
SCSI bus, ADU error messages D-17,
D-19, D-20
cabling order 2-10
cache
accelerator RAM, POST error
messages C-22, C-23
Index-4
ADU error messages D-2, D-3, D-4,
D-11, D-14, D-25
drive write D-24
cache accelerator Slot X
initialization failed C-23
cache accelerators not
installed C-22
cache controller error C-15
cache has been disabled
because ADG enabler dongle
is broken or missing D-5
cache memory error C-14
cache test failed B-2
cache was automatically
configured, accelerator
status D-2
Caldera and SCO operating systems
drivers, accessing latest 3-13
EFS 3-13
emergency boot diskette 3-7
event list messages 4-17
kernel panic 4-17
recovery software 3-7
technical support, information
required 1-26
CarePaq A-3
CD-ROM drive
cannot read data 2-23
connection problems 2-24
drivers 2-24
invalid format 2-23
media problems 2-23
POST error messages C-4
problems 2-23
SCSI ID setting 2-26
system boot 2-23
test error codes B-14
undetected 2-24
USB problems 2-23
CD-ROM ID failed B-14
CD-ROM read failed B-14
invalid memory
configuration B-4
HP Servers Troubleshooting Guide