HP 1850R - ProLiant - 128 MB RAM Troubleshooting Manual page 300

SCSI port X, Drive ID Y RIS
copies within this drive do
not match D-15
SCSI port X, Drive ID Y
S.M.A.R.T. predictive
failure errors have been
detected D-16
SCSI port X, Drive ID Y was
replaced on a good
volume D-16
SCSI tape drive test error codes B-15
SCSI tape ID drive types test
failed B-15
SCU (System Configuration Utility)
accessing A-5
described A-5
Diagnostics, accessing 4-6
Inspect Utility, accessing 4-10
POST error messages C-6
search engines A-3
secondary disk controller
failure C-67
secondary disk port address
assignment conflict C-58
security
ASR-2 5-15
maintaining 5-15
serial number, BIOS, POST error
messages C-4
serial port address conflict
detected C-37
serial port test failed B-9
serial port, POST error messages C-37
serial/parallel interface board, test error
codes B-9
server
booting problems 1-6, 1-7, 1-8, 1-9,
1-10, 1-11, 1-12, 1-13, 1-14, 2-5,
2-6, 2-7, 2-8, 2-9, 2-10, 2-11, 2-12,
2-16
changes, problem prevention 6-2
failure, backup plan 6-5
maintenance, Integration Maintenance
Utility 6-3
HP Servers Troubleshooting Guide
maintenance, suggestions 6-5
management, website 4-8
naming conventions 6-5
periodic visual check 6-7
powering down 1-3
shutdown procedure 1-3
software updates, Integration
Maintenance Utility 6-3, 6-4
server blade health driver 4-18
Server Feature Board is not
properly cabled to the
system C-30
Server Feature Board must be
installed in slot 1 for
proper operation C-30
Server Feature Board, POST error
messages C-30
server management 4-8
64-bit systems 4-8
accessing A-5
component information, collecting 1-13
described 4-8
error messages 1-12
predictive failure alert 2-30
problem diagnosis 3-1
resources A-9
utilization rate/traffic, determining 1-17
version conflict 1-16
version control option 6-4
website A-5
server management board is in
the wrong slot C-44
server response time 2-25
server setup utility
BIOS Setup Utility A-6
RBSU A-5
SCU A-5
server-specific user documentation
accessing 1-2, 2-37, A-2
defined xii
service pack, installation problems 3-3
set configuration command
issued D-16
Index
Index-25