Resizing Input - Brother BAS-311E Instruction Manual

Chapter 3 Programming with Command Function
Ending program
1. Press .
P

Resizing input

Programming
1. Press .
P
The work clamp moves to the home position and the
programmer screen is displayed.
2. Press
9 0
is the command for resizing input. Input the
9
magnification (02, 05, 10) in
3. Move the work clamp with
when the needle point is at point A of the
L
pattern.
The first stitch (point A) is programmed.
4. Repeat step 3 and create the program to
point D.
Inputting the end code
1. Press
L
1 1 1 E
The work clamp returns to the start position.
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
126
.
5 M
.
at the last stitch and press
.
Resizing input is used to program a detailed pattern
stitch by stitch. The example in the left is used for
explanation of programming the pattern to the
magnification of 5.
. Press
Programmer