Brother BAS-311E Instruction Manual page 159

Chapter 3 Programming with Command Function
Moving to position 1
1. Press
9 9
The work clamp moves from the start point by each stitch.
2. Press when the needle is at 1.
The work clamp stops. If the work clamp passes, input a few
stitches and press
the input.
Moving in parallel
1. Press
7 7
Input the command for parallel movement.
2. Move the work clamp with
when the needle point is at 2 of the
L
pattern.
If pattern C is present after pattern B, pattern C is automatically
moved in parallel. If this is not preferred, move pattern C in
parallel as in steps
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
Ending program
1. Press .
P
158
and press .
9
. The needle returns for a few stitches of
and press .
F
7
and .
. Press
Programmer