Chapter 2 Programming with Help Function
Saving
1. Select
with
2. Select
with
3. Input the data number and press
4. Press
.
ESC
ESC
Ending program
1. Press
.
P
Multiple stitch
Programming can be started from either inside or outside line. Embroidering is carried out in the sequence of
programming.
Embroidering direction depends on programming sequence.
When embroidering direction should be changed at a sharp angle, a split should be provided in the vicinity of the
direction change point for finishing the multiple stitch in relatively uniform conditions.
Up to 200 points can be specified for one side. If you attempt to input 201 or more points, the needle point is
automatically returned to the previous points. In that case, start inputting points of the outside (or the inside) line,
or reconsider point input positions or pattern.
48
and press
.
and press
.
.
This section describes programming of a multiple
stitch. Refer to the example on the left.
Programmer