Ending program
1. Press
.
P
Lines
Programming
1. Press
.
P
The work clamp moves to the home position and the
programmer screen is displayed.
2. Move the work clamp with
when the needle point is at point A of the
L
pattern.
The first stitch (point A) is programmed.
3. Input the stitch length.
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
4. Press
.
LI LI
To change the stitch length, specify the pitch value before
pressing
.
LI LI
5. Move the work clamp with
when the needle point is at point B of the
L
pattern.
6. Repeat steps 4 and 5 and create the program
to point E.
Inputting the end code
1. Press
at the last stitch and press
L
.
1
1
1
E
The work clamp returns to the start position.
Chaprter 3 Programming with Command Function
The pattern with lines is programmed.
The example in the left is used for explanation of
programming.
. Press
. Press
Programmer
127