Motorola WiNG 5.5 Reference Manual page 148

5 - 62 WiNG 5.5 Access Point System Reference Guide
5. Set the following
Host Name
Router ID
UDP Listen Port
Tunnel Bridging
6. Select the L2TPv3 Tunnel
Figure 5-32 Network - L2TPv3 screen - General tab
General Settings for an L2TPv3 profile configuration:
Define a 64 character maximum hostname to specify the name of the host that's sent
tunnel messages. Tunnel establishment involves exchanging 3 message types (SCCRQ,
SCCRP and SCCN) with the peer. Tunnel IDs and capabilities are exchanged during the
tunnel establishment with the host.
Set either the numeric IP address or the integer used as an identifier for tunnel AVP
messages. AVP messages assist in the identification of a tunnelled peer.
Select this option to set the port used for listening to incoming traffic. Select a port from
1,024 - 65,353.
Select this option to enable or disable bridge packets between two tunnel end points. This
setting is disabled by default.
tab.