Motorola WiNG 5.5 Reference Manual page 736

12 - 54 WiNG 5.5 Access Point System Reference Guide
4. Select the Refresh
within the RF Domain.
CAUTION: Smart RF is not able to detect a voice call in progress, and will switch to a
different channel resulting in voice call reconnections.
Select the Interactive Calibration
The results of the calibration display within the Smart RF screen. Of particular interest are the channel and power
adjustments made by the Smart RF module. Expand the screen to display the Event Monitor to track the progress of the
Interactive Calibration.
5. Select Calibration Result Actions
results of an Interactive calibration are not applied to radios directly, the administrator has the choice to select one of
following options.
• Replace - Only overwrites the current channel and power values with the new channel power values the Interactive
Calibration has calculated.
• Write - Writes the new channel and power values to the radios under their respective device configurations.
• Discard - Discards the results of the Interactive Calibration without applying them to their respective devices.
• Commit - Commits the Smart RF module Interactive Calibration results to their respective access point radios.
6. Select the Run Calibration
not written to the running-configuration. These values are dynamic and may keep changing during the course of the run-
time monitoring and calibration the Smart RF module keeps performing to continually maintain good coverage. Unlike an
Interactive Calibration, the Smart RF screen is not populated with the changes needed on access point radios to remedy a
detected coverage hole. Expand the screen to display the Event Monitor to track the progress of the calibration.
The calibration process can be stopped by selecting the
button to (as required) to update the contents of the Smart RF screen and the attributes of the devices
button to initiate a Smart RF calibration using the access points within the RF Domain.
to define the actions taken based on the results of an Interactive Calibration. The
Figure 12-49 Save Calibration Result screen
option to initiate a calibration. New channel and power values are applied to radios, they are
Stop Calibration button.