Motorola WiNG 5.5 Reference Manual page 169

14. Set the OSPF Area configuration.
Area ID
Authentication Type
Type
Default Cost
Translate Type
Range
15. Select the OK button to save the changes to the area configuration. Select
16. Select the Interface Settings
17. Review existing Interface Settings
Name
Type
Description
Admin Status
VLAN
IP Address
Use the drop-down menu and specify either an IP address or Integer for the OSPF area.
Select either None, simple-password or message-digest as credential validation
scheme used with the OSPF dynamic route. The default setting is None.
Set the OSPF area type as either stub, totally-stub, nssa, totally-nssa or non-stub.
Select this option to set the default summary cost advertised if creating a stub. Set a
value from 1 - 16, 777,215.
Define how messages are translated. Options include translate-candidate,
translate-always and translate-never. The default setting is translate-candidate.
Specify a range of addresses for routes matching address/mask for OSPF
summarization.
tab.
Figure 5-45 Network - Interface Settings tab
using:
Displays the name defined for the interface configuration.
Displays the type of interface.
Lists each interface's 32 character maximum description.
A green check mark defines the interface as active and currently enabled with the
profile. A red "X" defines the interface as currently disabled and not available for use.
Lists the VLAN IDs set for each listed OSPF route virtual interface.
Displays the IP addresses defined as virtual interfaces for dynamic OSPF routes. Zero
config and DHCP can be used to generate route addresses, or a primary and secondary
address can be manually provided.
Device Configuration 5 - 83
Reset to revert to the last saved configuration.