Motorola WiNG 5.5 Reference Manual page 486

6 - 60 WiNG 5.5 Access Point System Reference Guide
6. Configure the following parameters in respect to the intended
Multicast Mask Primary
Multicast Mask
Secondary
7. Set the following
Disable Multicast
Streaming
Figure 6-25 WLAN - WLAN QoS Policy Screen - Multimedia Optimizations
Configure the primary multicast mask for each listed QoS policy. Normally all multicast
and broadcast packets are buffered until the periodic DTIM interval (indicated in the
802.11 beacon frame), when clients in power save mode wake to check for frames.
However, for certain applications and traffic types, an administrator may want the frames
transmitted immediately, without waiting for the DTIM interval. By configuring a primary
and secondary multicast mask, an administrator can indicate which frames are
transmitted immediately. Setting masks is optional and only needed if there are traffic
types requiring special handling.
Set a secondary multicast mask for the WLAN QoS policy. Normally all multicast and
broadcast packets are buffered until the periodic DTIM interval (indicated in the 802.11
beacon frame), when clients in power save mode wake to check for frames. However, for
certain applications and traffic types, an administrator may want the frames transmitted
immediately, without waiting for the DTIM interval. By configuring a primary and
secondary multicast mask, an administrator can indicate which frames are transmitted
immediately. Setting masks is optional and only needed if there are traffic types requiring
special handling.
Accelerated Multicast settings:
Select this option to disable all Multicast Streaming on the WLAN.
Multicast Mask: