Motorola WiNG 5.5 Reference Manual page 673

Module
Source
Message Substring
NOTE: Leave the Source, Device and Mobile Unit fields at the default setting of
00:00:00:00:00:00 to allow all MAC addresses.
4. Select the Add to Active Filters
the filter uses the configuration defined in the Customize Event Filters field.
5. Refer to the Active Event Filters
a. To activate all the events in the
generation, select Disable All
b. To enable an event in the
NOTE: Filters cannot be persisted across sessions. They must be created every time a
new session is established.
6. Select View Events from the upper, left-hand, side of the Fault Management browser.
Use the View Events screen to track and troubleshoot events using source and severity levels defined in the configure
events screen.
7. Refer to the following event parameters to assess nature and severity of the displayed event:
Timestamp
Select the module from which events are tracked. When a single module is selected,
events from other modules are not tracked. Remember this when interested in events
generated by a particular module. Individual modules can be selected (such as TEST, LOG,
FSM etc.) or all modules can be tracked by selecting All Modules.
Set the MAC address of the source device being tracked. Setting a MAC address of
00:00:00:00:00:00 allows all devices to be tracked.
Set the error message search string. This filters out any error message or event message
that does not contain the string being searched.
button to create a new filter and add it to the
table to set the following parameters:
Active Events Filters
Events.
Active Event Filters table, select the event, then select the
Figure 11-2 Fault Management - View Events screen
Displays the timestamp (time zone specific) when the event occurred.
Active Event Filters
table, select the Enable All Events
Diagnostics 11 - 3
table. When added,
button. To stop event
Activate Defined Filter button.